For the required SPI measurement draw the control ...

Discussion in 'General Discussions' started by _Alka7476, Jun 8, 2017.

  1. _Alka7476

    _Alka7476 Member
    Alumni

    Joined:
    May 17, 2017
    Messages:
    4
    Likes Received:
    0
    For the required SPI measurement draw the control chart. Here the specification limits are +/- 20%--How do w do this? Need help plz
     
    #1
  2. Priyamwada

    Priyamwada Well-Known Member
    Simplilearn Support

    Joined:
    Dec 10, 2015
    Messages:
    757
    Likes Received:
    86
    Hi Alka,

    You can consider the Mean as 1 and consider upper limit as 1.1 and 1.2 and lower limits as 0.9 and 0.8
    Hope this resolves your query!

    Happy Learning!!
    Priyamwada Singh - Global Teaching Assistant
     
    #2
  3. Laxman Daulat Pawar

    Laxman Daulat Pawar New Member

    Joined:
    Aug 11, 2017
    Messages:
    1
    Likes Received:
    0
    Hi Priyamwada,

    Thank you for the above help provided.

    Appreciate if you can advise me on the below query.

    C. For the required SPI measurement draw the control chart. Here the specification limits are +/- 20%.

    I have completed the control chart using mean as 1 and UCL as 1.1 and LCL as 0.9. But still confused if what needs to be done with the below chart which has the defects.

    The testing team reports the following defects against each category:

    Category

    Defects

    Requirements understanding

    22

    Skill

    35

    Unit testing

    42

    Architecting

    12

    D. For the above table plot the 80/20 rule chart.

    Please can you advise if the above plot needs to be used for Question C or Question D or for both?

    Looking forward to your help and support.

    Regards,
    Laxman Pawar
     
    #3
  4. Astha Wadhwa

    Astha Wadhwa Member

    Joined:
    May 18, 2017
    Messages:
    7
    Likes Received:
    0
    Hi , you must have complted this by now. Can u help and guide me on proj 4 plz. Thanks much !!
     
    #4
  5. Mukesh Sahu

    Mukesh Sahu Moderator
    Simplilearn Support

    Joined:
    Feb 2, 2011
    Messages:
    805
    Likes Received:
    57
    Hi Astha,

    We have shared the recording of a Project submission session. You will find the answer to the project there
     
    #5
  6. PrasKumar

    PrasKumar Member
    Alumni

    Joined:
    Jun 27, 2017
    Messages:
    3
    Likes Received:
    2
    Can you please share your answer..
     
    #6
  7. _13535

    _13535 Member

    Joined:
    Oct 10, 2017
    Messages:
    2
    Likes Received:
    0
    Hi Mukesh, Can you please share the recording on my email id koushikroy.edu@gmail.com
     
    #7

Share This Page